Applied Catia - L Scott Hansen

. .

Résumé :

Getting Started

• Create a simple sketch using Sketcher Workbench commands
• Dimension a sketch using the Constraint command
• Extrude a sketch using the Pad command
• Create a fillet using the Edge Fillet command
• Create a hole using the Extruded Cut command
• Create a counter bore using the Hole command

Learning More Basics

• Revolve a sketch using the Shaft command
• Create a hole using the Extruded Cut command
• Create a series of holes using the Circular Pattern command

Learning to Detail Part Drawings

• Create an Orthographic view using the Drawing commands

Advanced Detail Part Drawings

• Create an Auxiliary View using the Drafting commands
• Create an Offset Section View using the Drafting commands
• Dimension views using the Forced Vertical Dimension in View command
• Create Text using the Drawing Annotation commands

Learning to Edit Existing Solid Models

• Edit the part using the Edit Sketch command
• Edit the part using the Edit Pad command

Advanced Design Procedures

• Learn to use the Front, Top, and Right Planes
• Learn to use the Wireframe viewing command
• Learn to project 3D Elements on to a new sketch
• Learn to use the Shell command

Introduction to Assembly View Procedures

• Learn to insert existing solid models using the Assembly commands
• Learn to constrain all parts using the Constraint command
• Learn to edit/modify parts while in the Assembly command
• Learn to manually simulate motion